Instructions for Installing Ghost Shadow Lights

1. Turn off the factory puddle Light
To conserve energy and keep the power light from running out during installation, use a screwdriver to lock in the door lock mechanism. This is generally found on the side of the entranceway. This will effectively keep carefully the power light from coming on when the door is open. Some vehicles may use door pins, you will want to disconnect the battery on these cars.

2. Remove the Door Panel.
The next step in installing ghost shadow lights is to remove the door panel. The exact method varies from car to car, but usually involves first removing the trim (handle, window roller, etc), then removing screws with an appropriately sized screwdriver. Lastly, unlatch the pop clips by gently pulling, and the entranceway panel should be able to be removed.

3. Drill a Hole for the Ghost Shadow Light
;Choose a spot for the logo light in the bottom of the door panel that's facing the ground. Ideally, this location should be flat. Using a cordless drill and the included
drill bit to drill the hole Wipe off any excess debris before continuing.

4. Set the Ghost Shadow Light into the Hole
Get the courtesy light (ghost shadow light). Arranged it in to the hole that's just been drilled, then secure the light into the location by tightening the retaining. Quickly
power up the ghost shadow light and verify the angle , Once verified Snug down the retaining screw to secure the light; these will hold the light into place.

5. Wire the Ghost Shadow Light in to the Door Light
Tap into the existing wires in the entranceway panel to light up the ghost shadow light. Take away the insulation tape covering the wires with a screwdriver or craft knife.Once the insulation tape has been pushed back, split the wires apart. Then take the wire cutter and strip the rubber off the two wires so that the interior copper metal is showing; do this same thing with the cables on the light. Then, tie the logo design light wire into the car door's two light wires by wrapping it around both wires gently.If you do not have a preexisting wiring you will need to run cables for the dome light and run them in to the door, you may have to use a relay if the dome light circuit is low amperage.

6. Test the Ghost Shadow Light
First, turn on the power light and then test to see if the LED voiture light comes on with the rest of the lights when the door is opened. If it does, it's time to cover the
wires with shrinking tubing.

7. Reinstall the Door Panel
Reinstall the entranceway panel and secure the pop clips, but wait to use the screwdriver. If any extra wire is hanging below the
door, slip it up inside the door panel. Check to make sure all the buttons and lamps are working as they should, and screw the door panel back in securely.

8. Repeat the Process for all Other Doors .If desired, install a ghost shadow light on the opposite door.